Filter
Top Products
4
2. Close main and pilot gas supply by partially
depressing and turning ON/OFF knob to the “OFF”
position.
Figure 2-3
Millivolt Safety Pilot Valve
3. Turn main ON/OFF supply line gas valve to the “ON”
position.
4. Have your plumber or gas company representative
check for leaks with a soap solution. (Never check
with a match!)
WARNING
PROPANE GAS MAY EVENTUALLY LOSE ITS
ODOR AND PRECAUTIONS SHOULD BE TAKEN TO
ASSURE THAT PROPANE GAS IS NOT PRESENT
EVEN THOUGH YOU DO NOT DETECT AN ODOR.
IF THERE IS ANY DOUBT, YOU SHOULD CALL
YOUR LOCAL PROPANE GAS SUPPLIER FOR
ASSISTANCE.
III OPERATING
LIGHTING
Lighting instructions are also listed on the lighting
instruction plate attached to the front of the air shield.
1. Turn the ON/OFF switch to the “OFF” position.
2. Turn gas valve knob to pilot position.
Figure 3-1
Millivolt Safety Pilot Valve
3. Depress and hold gas valve knob while repeatedly
pushing red button (Piezo spark ignitor) on control
panel until pilot flame is established. Allow pilot to
burn 90 seconds before releasing gas valve knob.
This will allow the thermopile to reach its maximum
millivolt and milliamp output.
NOTE: Allow pilot to burn one additional minute before
turning thermostat dial to desired position. Pilot flame
should be blue in color and high enough to envelop the
tip of the thermopile to activate the gas safety valve.
Figure 3-2
Piezo Spark Ignitor
4. Turn gas valve knob to “ON” position.
5. Turn ON/OFF switch to “ON” position.
6. Set thermostat dial to desired temperature. When
the griddle plate reaches the temperature setting the
main burners will extinguish.
DURING INITIAL INSTALLATION,
AFTER OVERNIGHT
SHUTDOWN, OR WHEN
RELIGHTING, AIR IN THE
SUPPLY LINE MAY MAKE IT
NECESSARY TO HOLD THE
GAS VALVE IN THE
DEPRESSED PILOT POSITION
FOR A LONGER THAN NORMAL
PERIOD OF TIME. WAIT FIVE
MINUTES BEFORE REPEATING
LIGHTING PROCEDURE TO ALLOW ANY GAS
WHICH MAY HAVE ACCUMULATED IN THE
BURNER COMPARTMENT TO ESCAPE.
NOTE: If you have difficulty lighting the pilot:
1. Place ON/OFF switch to the “OFF” position.
2. Wait five minutes before relighting.
3. Repeat Steps 2 - 6 of Lighting Instructions.
CONDITIONING THE
GRIDDLE
The MIRACLEAN® Griddle plate has been “seasoned”
at the factory. The chrome surface, when heated
creates a thin layer of chrome oxide which acts as a
releasing agent for food product. If you feel you need to
recondition, the following instruction should be
followed: