Filter
Top Products
11
Setting Temperature Display — Fahrenheit or Celsius
The and pads control the Fahrenheit or Celsius temperature display modes. The oven control can be programmed
to display temperatures in Fahrenheit or Celsius. The oven has been preset at the factory to display in Fahrenheit. Note: both
ovens will be changed at the same time.
Setting Accent Light
Your range includes a decorative Accent Light centered horizontally across touch-sensitive control panel. The Accent light
comes with a theatre style intensity feature that slowly increases brightness at turn on and slowly fades when turning o.
When the Accent light is o, the light is in automatic mode. This means the Accent light will turn on automatically when an
oven or Timer has been activated. The Accent light will turn o automatically when these functions are no longer active.
When the Accent light is OFF, it may be turned ON by pressing
once. When the Accent light has been manually turned
on, it will remain on until manually turned o by pressing
again. The brightness may also be adjusted.
Operating Oven Lights
The interior oven lights will turn ON when the oven door is opened.
Press
to turn oven light ON an OFF whenever the oven door is closed.
The interior oven lights are located on the rear wall of the oven interior and are covered with a glass shield. The glass shield
protects the bulb from high temperatures and should always be in place whenever the oven is in use.
To replace the interior oven lights, see Replacing oven lights in the Care and Cleaning section.
To change display from Fahrenheit to Celsius or Celsius to
Fahrenheit
1. Press and hold for 7 seconds. A beep will sound, "550" will
appear "UPPER" and "BROIL" will ash in the display (Fig. 1).
After 6 seconds a beep will be heard and "F" (Fig. 2) or "C" (Fig.
3) will appear in the display.
If "F" appears, the display is set to show temperatures in
Fahrenheit (Fig. 2). If "C" appears, the display is set to show
temperatures in Celsius (Fig. 3).
2. Press
to switch between Fahrenheit or Celsius display modes.
The display will show either "F" (Fig. 2) or "C" (Fig. 3).
3. Press
to accept the change or press to reject the
change.
Example - To adjust the Accent light brightness:
1. Press and hold until an acceptance tone sounds (about 6
seconds).
2. The default setting of 100 will appear in the display (See Fig. 4).
3. Using the numeric keypad, enter any digit from
0 to 100 to
change the brightness level. Entering
0 (Fig. 5) will eectively
turn the Accent light OFF until the brightness level is adjusted to a
higher level.
4. Press
to save the desired brightness setting.
for 7seconds
or
Value between
0 to 100
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Consumer Dened Control
INSTRUCTIONS PRESS DISPLAY
INSTRUCTIONS PRESS DISPLAY