Filter
Top Products
MATERIALS YOU MAY NEED
Lag Bolts Anchor Sleeves
(For Antl_Tlp Bracket Mounted
on Concrete Floors Only)
Tin Snips
(UL Approved 40 AMP)
4*Wtre Cord OR 3-W|re Cord
4' Long 4' Long
Squeeze Connector
(For Conduit installations Only)
TOOLS YOU WILL NEED
Drill with 118_ Bit
Safety Glasses
2. Prepare the Opening
Allow 11/4'spacing from the range to adjacent vertical
walls above the cooktop surface,
Allow 30" minimum clearance between the surface units
and the bottom of unprotected wood or metal top cabinet,
and 15" minimum between the countertop and adjacent
cabinet bottom
EXCEPTION: Installation of a listed microwave oven
or cooking appliance over the cooktop shall conform
to the insta!lation instructions packed with that
appliance.
If cabinet storage is installed, reduce the risk by
installing a range hood that projects horizontally a min, of
5" beyond the bottom of the cabinets,, Make sure the wall
covering, countertops and cabinets around the range can
withstand heat generated by the range, oven or cooktop
up to 200°E
Not less than the
Hood width o! the range
Adiustable Wrench
Tape Measure
Locate the outlet box wllhln
either shaded area.
Pliers
Pencil
1/4" Nut Dr|ver
PhllI]ps Screwdriver
Level
Flat-blade Screwdriver
PARTS INCLUDED
AntI-T_p Bracket Kit
PREPARE TO INSTALL THE RANGE
1. Remove Shipping Material
Remove packaging materials, Failure to remove
packaging materials could result in damage to the
appliance..
Install the
outlet box on
either side of
the _.
box
Flooring under the range
Your range, like many other household items, is
heavy and can settle into soft floor coverings such as
cushioned vinyl or carpeting.
When moving the range on this type of flooring, it should
be installed on a !/4" thick sheet of plywood (or similar
material) as follows:
When the floor covering ends at the front of the range,
the area that the range will rest on should be built up
with plywood to the same level or higher than the floor
covering. This will allow the range to be moved for
cleaning or servicing..
16