Filter
Top Products
INSTALL 'THE RANGE
8. Replace the Wire Cover
Replace the wire cover on the range back by sliding its
right edge under the retaining tab and replacing the two
screws removed eartier_ Make sure that no wires are
pinched between the cover and the range back,
2 sorews to
replace wire,
cover
\
cover
• • # u
9. Anti-Tip Device Installation
An Anti-Tip bracket is supplied with instructions for
installationin a variety of locations, The instructions
includeall necessary information to complete the
installation,,Read the Safety Instructions and the
instructionsthat fit your situation before beginning
installation,
10. Level the Range
a. tnstaltthe oven shelves in the oven and position the range
where itwiltbe installed
b.Check for levelness by placing a
spirit level or a cup, partially filled
with water, on one of the oven
shelves, If using a spirit level,
take two readings--with the level
placed diagonally first in one
direction and then the other,,
Spirit level
c. Remove the storage drawer, broiler drawer or kick
panel, The front leveling legs can be adjusted from the
bottom and the rear legs can be adjusted from the top or
the bottom,
Front leveling legs
(on some models)
Raise Lower
rang_ range
Bracket. / Wali plate
Screw "",,,d
tm"_tenter _IIl ,J,
woodor--........ Iil
Typical installation of antl-ttp bracket attachment to walt
WARNING:
• Range must be secured by Anti-Tip bracket supplied.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip device
WB2X7909, Call 1-800-4-MY-HOME ®,
• See instructionsto install (suppliedwith bracket),
• Unless properly installed, the range could be tipped by
stepping or sitting on the door. Injury may result from
spilled hot liquids or from the range itself,.
Rear leveling legs
(on some models)
d. Use an open-end or adjustable wrench to adjust the
leveling legs until the range is level,,
e. Replace the drawer or panel,
21