Filter
Top Products
3. Push release lever toward bulb, The left end of the light
assembly will raise up.
1 2 3 For normal range use, it is not suggested to remove the oven
door. However. if necessary, follow these instructions. The oven
_-_ _- door is heavy -
/" _ Before Removing:
__J/ 1. Use knife screwdriver and insert it at the bottom
a
putty
or
corner of the door Stop clip
I. Starter
2. Release lever
3. Bulb
4. To remove starter turn it counterclockwise and lift out of its
mounting Base.
5. To remove bull roll it forward or backward 90 ° until it clicks
then lift out
To Install Starter and/or Bulb:
1. Fit starter prongs into starter mounting base and turn
clockwise,
2,
I
1
(I
I. Door Stop Clip
Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3. Repeat procedure for other door Stop CIiD
To Remove:
1. OPen the oven door, Insert door removal Dins _ncluded with
your range nto both hinge hangers. Do not remove the Dins
while the door is removed from the range.
Slide bulb 3rongs into bulb mounting 3ase ends. Roll the bulb
forward or backward 90 ° until it clicks.
1
2
\
\
\
\ i ""
\
3. Push down on the left end of the bulb mounting base. When
the assembly latches, it will CI_CK
4. Replace lens cover, Position the two rear lens cover tabs in
front of the two metal spnng cl_ps {located d_rectly behind the
bulb) Push back and down on the lens cover to lock into
DOSIDOn,
5. Plug in range or reconnect power.
1, Removal pins
2. Hinge hanger
2, Carefully close the door until it rests against the door remora
DINS,
3. Graso the door on the sides w_th your fingers on the front of
the door and your thumbs on the inside surface.
4. Pull door straight up then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove aoo_
removal pins until the door is replaced on the range.
22