Filter
Top Products
Sea ed Su ace Burners
IMPORTANT: Do not obstruct the flow of combustion and
venblahon air around the burner grate edges
To Clean:
IMPORTANT: Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Do not use oven cleaners bleach
or rust removers.
1. Remove me Burner cap from the burner base and clean
accor@ng to "General Cleaning section,
2. Clean the gas tube opening w_th a aamp cloth
3. Clean cloggea burner Botts w_th a straight pin as shown, Do
not enlarge or distort the port. Do not use a wooaen
toothpick, If the burner needs to be adjusted contact a Sears
trmned repair specialist,
\
\
4
[
1. Burner cap
2. Burner base
3. Alignment pins
4. tgnl_or
5. Gas tube opening
4=
Replace the burner caB. making sure the alignment pros are
Brooerly aligned with the burner caB.
Burner cap: Always keep the burner cap Jn place when using a
surface burner. A clean burner cap w=ll he]p Brevent poor ignition
and uneven flames. Always clean the burner cap after a sp_ll-over
and routinely remove and clean the CaDSaccording 1othe
General Cleaning" section,
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other
matenal to enter the gas tube oBening. Protect Jtfrom spillovers
By always using a burner cap
- 2
7, Incorrect
2. Correct
5. Turn on the burner. If the burner does not light, check cab
alignment, If the burner still does not light, do not service the
sealed Burner yourself aut contact a trained repair specialist
1. 1-1½ (25-38mm)
2. Burner ports
Burner ports: Check burner flames occasionally for proper s=ze
and shade as shown above. A good flame is blue in coloi no[
yellow. Keen this area free of soil and do not allow sp=lls, fooc
cleaning agents or any other material to enter the burner ports.
8