Filter
Top Products
Setting the Clock
Setting the Clock
The Q pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset
at the factory for the 12 hour operation. When the range is first plugged in_ or when the power supply to the range has been
interrupted_ the time in the display wiil flash.
Press _. The display will stop flashing.
iNSTRUCTiONS PRESS DISPLAY
To set the clock (example below for 1:30)
1. Press Q. "CI-O" wiJJappear in the display (Fig. 1). (_)
2. Press ] 3 0 pads to set the time of day to 1:30 (Fig. 2). Press STy. ] 3 0
The time of day will appear in the display (Fig. 3).
Changing between 12 or 24 hour time of day dlsplay
1. Press and hold (_) for 7 seconds until "|2Hr" or "24Nr" appears in
the display.
Flex
2. Press cleo°to switch between the 12 and 24 hour time of day display.
The display will show either "|2Hr" (Fig. 4) or "24Nr" (Fig. 5).
3. Press _ to accept the change or press _ to reject the change.
4. Reset the correct time as described in To set the Clock above. Please
note that if the 24 hour time of day mode was chosen_ the clock wiii
now display time from 0:00 through 23:59 hours.
Q for 7 seconds
Flex
Clean
or press @
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
13