Filter
Top Products
Consumer Defined Control
Setting Temperature Display- Fahrenheit or Celsius
Flex
The _ and Cleanpads control the Fahrenheit or Celsius temperature display modes. The oven control can be programmed
to display temperatures in Fahrenheit or Celsius. The oven has been preset at the factory to display in Fahrenheit. Note: both
ovens wiJJ be changed at the same time.
iNSTRUCTiONS PRESS DISPLAY
To change display from Fahrenheit to Celsius or Celsius to
Fahrenheit
1. Press _ and hold for 7 seconds. A beep will sound, "550" will
appear "BROIL" will flash in the display (Fig. 1). After 7 seconds
a beep will be heard and "F" (Fig. 2) or "C" (Fig. 3) will appear in
the display.
.
If "F" appears, the display is set to show temperatures in
Fahrenheit (Fig. 2). If "C" appears, the display is set to show
temperatures in Celsius (Fig. 3).
Flex
Press aeonto switch between Fahrenheit or Celsius display modes.
The display wiii show either "F" (Fig. 2) or "C" (Fig. 3).
3. Press _(_ to accept the change or press _ to reject the change. _ or
_for 7seconds Fig. 1
Fig. 2
Flex
Clean Fig. 3
Setting Accent Light
Your range includes a decorative Accent Light located across the touch-sensitive control panel. The Accent light comes with
a theatre style intensity feature that slowly increases brightness at turn on and slowly fades when turning off.
When the Accent light is off, the light is in automatic mode. This means the Accent light will turn on automatically when an
oven or Timer has been activated. The Accent light will turn off automatically when these functions are no longer active.
Accent
When the Accent light is OFF, it may be turned ON by pressing Light once. When the Accent light has been manually turned
Accent
on, it will remain on until manually turned off by pressing Light again. The brightness may also be adjusted.
INSTRUCTIONS
Example - To adjust the Accent light brightness:
1.
PRESS DISPLAY
Accent
Press and hold Light until an acceptance tone sounds (about 6
seconds)
2. The default setting of 100 will appear in the display (See Fig. 4).
3. Using the numeric keypad, enter any digit from 0 to ]00 to
change the brightness level. Entering 0 (Fig. 5) will effectively
turn the Accent light OFF until the brightness level is adjusted to a
higher level.
4. Press _ to save the desired brightness setting.
Accent
Light
Value between
0 to 100
@
Fig. 4
Fig. 5
Operating Oven Lights
The interior oven lights will turn ON when the oven door is opened.
Press _ to turn oven light ON an OFF whenever the oven door is closed.
The interior oven lights are located on the rear wall of the oven interior and are covered with a glass shield. The glass shield
protects the bulb from high temperatures and should always be in place whenever the oven is in use.
To replace the interior oven lights, see Replaclng oven fights in the Care and Cleaning section.
16