Filter
Top Products
Genera Care & CReaning
Cleaning Various Parts of Your Oven
Before cbaning any part of the oven, be sure aH controUsare turned OFF and the oven is COOL, REMOVE SPULLOVERS
AND HEAVY SOUUNG AS SOON AS POSSBLE, REGULAR CLEANUNGS NOW WiLL REDUCE THE EXTENT AND
DiFFiCULTY OF MAJOR CLEANING LATER,
Surfaces How to C_ean
Aluminum (Trim Pieces) Use hot, soapy water and a cloth, Dry with a clean cloth, Do not scour or use all-
& Vinyl purpose cleaners, ammonia, powdered cleaners or commercial oven cleaner, They
can scratch and discolor aluminum,
Painted and Plastic
ControJ Panet, Body Parts,
and Decorative Trim
For general cleaning, use hot, soapy water and a cloth, For more difficult soils and
built-up grease, apply a liquid detergent directly onto the soil, Leave on soil for 30 to
60 minutes, Rinse with a damp cloth and dry, DO NOT use abrasive cleaners on
any of these materials; they can scratch,
To remove control knobs, turn to the OFF position; grasp firmly and pull straight off
the shaft, To replace knobs after cleaning, line up the flat sides of both the knob
and the shaft; then push the knob into place,
Stainless Steet, Chrome
Control Panel, Decorative
Trim
Before cleaning the contro/paneL turn all controls to OFF and remove the control
knobs, To remove, pull each knob straight off the shaft, Clean using hot, soapy
water and a dishcloth, Rinse with a clean water using a dishcloth, Be sure to
squeeze excess water from the cloth before wiping the panel; especially when
wiping around the controls, Excess water in or around the controls may cause
damage to the appliance,To replace knobs after cleaning, line up the flat sides of
both the knob and the shaft; then push the knob into place,
Clean stainless steet with hot, soapy water and a dishcloth, Rinse with clean water
and a cloth, Do not use cteaners with high concentrations of chlorides or
chlorines, Do not use harsh scrubbing cleaners, Only use kitchen cleaners that are
especially made for cleaning stainless steel, Always be sure to rinse the cleaners
from the surface as bluish stains may occur during heating that cannot be removed,
PorceJain EnameJ Broiler
Pan and insert, Door Liner,
Body Parts
Gentle scouring with a soapy scouring pad wiii remove most spots, Rinse with a 1:1
solution of clear water and ammonia, If necessary, cover difficult spots with an
ammonia-soaked paper towel for 30 to 40 minutes, Rinse with clean water and a
damp cloth, and then scrub with a soap°filled scouring pad, Rinse and wipe dry with a
clean cloth, Remove all cleaners or the porcelain may become damaged during future
heating, DO NOT use spray oven cleaners on the cooktop,
Oven and Broiler Racks
Non Self-Clean Models: Clean by using a mild, abrasive cleaner following manufacturer's
instructions, Rinse with clean water and dry, After cleaning the racks, rub the sides of
the racks with wax paper or a cloth containing a small amount of baby oil or salad oil (this
will make the racks glide easier into the rack position),
Self-Clean Models: Oven racks may be removed or left in the oven during the self=clean
cycle for cleaning, if removed, follow instructions above, if the racks are cleaned in the
self=clean cycle, their color will turn slightly blue and the finish will be dull, After the self=
clean cycle is completed and the oven has cooled, rub the sides of the racks with wax
paper or a cloth containing a small amount of baby oil or salad oil (this will make the racks
glide easier into the rack positions),
Oven Doo_
Use soap & water to thoroughly clean the top, sides and front of the oven door, Rinse
well, You may use a glass cleaner on the outside glass of the oven door, DO NOT
immerse the door in water, DO NOT spray or allow water or the gJass cleaner to
enter the door vents, DO NOT use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door,
DO NOT clean the oven door gasket, The oven door gasket is made of a woven
material, on Self°Cleaning models, which is essential for a good seal, Care should
be taken not to rub, damage or remove this gasket,
2O