Filter
Top Products
Genera Care & C eaning
Cteanin 9 the Porcelain Enamel Oven (ManuaJCbanOvenOnJy)
Porcelain has a smooth finish and is a type of glass fused to metal, Oven cleaners can be used on all interior oven
surfaces,REMOVE SPILLOVERS AND HEAVY SOiLiNG AS SOON AS POSSIBLE, REGULAR CLEANINGS NOW WiLL
REDUCE THE EXTENTAND DiFFiCULTY OF MAJOR CLEANING LATER,
Adhere to the following cJeaning precautions:
o Allow the oven to cool before cleaning,
o Wear rubber gloves when cleaning the appliance manually,
GeneraJ Cbaning
Remove soils using hot, soapy water, Do not allow food spills with a high sugar or acid content (such as milk, tomatoes,
saukerkraut, fruit juices or pie filling) to remain on the surface as they may cause a dull spot even after cleaning,
To Remove Heavy Soil
1, Allow a dish of ammonia to sit in the oven overnight or for several hours with the oven door closed,
Stand to the side of the oven when opening door to allow ammonia fumes to disperse, Clean softened
spots using hot, soapy water, Rinse well with water and a clean cloth,
2, if soil remains, use a soap°filled scouring pad or a nonabrasive cleaner, if necessary, use an oven cleaner following
manufacturer's instructions, _ DO NOT mix ammonia with other cleaners,
3, Clean any soil from the oven frame, the door liner outside the oven door gasket and the small area at the front center
of the oven bottom, Clean with hot, soapy water, Rinse well using clean water and a cloth,
Adhere to the following precautions when using oven cleaners:
1, DO NOT spray on the electrical controls or switches because it could cause a short circuit and result in sparking or
fire
2, DO NOT allow a film from the cleaner to build up on the temperature probe; it could cause the oven to heat improperly,
(The probe is located in the rear of the oven on the left side) Carefully wipe the probe clean after each oven cleaning,
being careful not to move the probe, A change in its position could affect how the oven bakes, Avoid bending the probe,
3, DO NOT spray any cleaner on the oven door trim or gasket, handles or any exterior surfaces of the appliance, wood or
painted surfaces, The cleaner can damage these surfaces,
Ammonia must be rinsed from all surfaces before operating the oven, Provide adequate ventilation,
DO NOT line the oven walls, bottom, racks or any other part of the appliance with aluminum foil, Doing so
will destroy heat distribution, produce poor baking results and cause permanent damage to the oven
foil will melt to the interior surface of the oven),
CWeanin9 the Oven Bottom
The oven bottom in non self-cJean oven modeJs can be removed for cleaning. See "To Remove and Replace Oven
Bottom" in this General Care & Cteaning section,
Clean using hot, soapy water, a mild abrasive cleanser, a soap=filled abrasive pad or oven cleaner following manufacturer's
instructions,
Care and Cteanin 9 of Stainless Steel (somemodets)
Some models are equipped with stainless steel exterior parts, Special care and cleaning are required for maintaining the
appearance of stainless steel parts, Please refer to the table provided at beginning of this GeneraJ Care & Cteaning section,
21