Filter
Top Products
7
Removing the Water Inlet Valve
1. Turn off the water supply to the dishwasher.
2. Turn the timer knob clockwise to the NORMAL WASH position to energize the water inlet valve
and relieve water pressure in the line.
3. Turn the electrical supply to the dishwasher off and remove the toe panel and access panel.
(Fig. 1-14)
4. Disconnect the wiring harness connector from the
water inlet valve terminals.
(Fig. 1-15)
5. Disconnect the water lines from the water inlet valve.
6. Remove the Hex-head screw securing the water inlet
valve to the tub support assembly.
Fig. 1-14
Removing the Thermal Fuse
1. Turn the electrical supply to the dishwasher off and
remove the toe panel and access panel.
2. Disconnect the orange and white wires from the thermal
fuse terminals.
(Fig. 1-16)
3. Remove the Hex-head screw securing the thermal fuse
to the tub and remove the thermal fuse from the dishwasher.
Removing the Float Switch
1. Turn the electrical supply to the dishwasher off and
remove the toe panel and access panel.
2. Remove the Hex-head screw securing the float switch
to the tub.
(Fig. 1-17)
3. Lift the float from the housing inside the tub.
4. Unsnap the float switch housing cover and disconnect
the two (2) wires from the terminals of the switch.
(Fig. 1-18)
THERMAL
FUSE
RETAINING
SCREW
WHITE
WIRE
ORANGE
WIRE
Fig. 1-16
Fig. 1-15
FLOAT
SWITCH
HOUSING
RETAINING
SCREW
Fig. 1-17
WIRES
TERMINALS
SWITCH COVER
Fig. 1-18