Filter
Top Products
46
Fig. 3-10
Fig. 3-11
Dishwasher Dispenser Disassembly
1. Remove the drawbar spring.
(Fig. 3-10)
2. Grasp the lower edge of the drawbar and
pull it away from the panel stop. Slide the
drawbar down until the drawbar holes align
with the locking tabs, then remove the
drawbar. Note how the locating tabs be-
hind the drawbar align with their respec-
tive locating holes in the drawbar.
(Fig. 3-
11)
3. Turn the wet agent cap and seal assem-
bly counterclockwise and remove it.
(Fig. 3-12)
4. Remove the seal from the cap.
5. Use Special Tool - Part No. 303918 or a
¾” socket to press over the attaching tabs
in the wet agent cap opening. Remove
wet agent dispenser assembly.
(Fig. 3-12)
6. Remove wet agent dispenser actuator by
spreading the two (2) locking tabs.
(Fig.
3-13)
7. Remove the actuator slide from the wet
agent dispenser actuator.
8. Remove the diaphragm spring and
diaphragm.
9. Use a screwdriver to gently release the
lower tab and remove the detergent door
actuator assembly. As you do, note the
position of the door latch level through
the hole in the lower slide.
(Fig. 3-14)
10. Remove the detergent door latch by care
fully spreading the latch snap locking tabs
apart with a screwdriver while pushing
firmly against the end of the door latch
lever until the lever is released through the
hole.
11. Remove the upper slide, the slide
spring and the lower slide.
(Fig. 3-15)