Filter
Top Products
31
ACCESSING COMPONENT INSIDE THE DISHWASHER DOOR
Removing Access and Outer Door
Panels
1. Loosen but do not remove the two (2) toe
panel screws below the access panel. Re-
move and set aside the two (2) screws above
the access panel.
(Fig. 2-11)
2. Remove the access panel assembly by slid-
ing it upward to clear the loosened screws.
(Fig. 2-11)
3. Remove the two (2) screws from the bottom
of the outer door panel.
(Fig. 2-11)
4. Pull the bottom of the outer door panel out-
ward and slide it down approximately ¼” to
½”. The panel will then be free for removal.
(Fig. 2-11, inset)
5. Remove the existing door insulation. Access
to the detergent and rinse aid dispensers is
now possible.
Fig. 2-11
1. Disconnect the dishwasher from the electrical
supply.
2. Disconnect the end of the door springs
from the door spring tension adjustment
holes in the frame runner.
3. Open the dishwasher door and remove the
eight (8) T-15 Torx screws securing the inner
door panel from the door frame.
(Fig. 2-12)
4. Slide the inner door panel back toward the dish-
washer to disengage the spring loaded locking
tab from the door panel, then lift the door panel
away from the door.
(Fig. 2-13)
4. Remove the control cover.
Removing the Inside Door Panel
Fig. 2-13
T-15
TORX
Fig. 2-12
Spring Loaded
Locking Tab
Inner Door
Panel
SLIDE INNER DOOR
PANEL TOWARD
DISHWASHER