Filter
Top Products
Brewing Hot Water
Your Brewer is able to produce hot water for making hot cocoa in a packet,
for use in cooking, for making soups, etc. Simply raise and lower the Handle
on the Brewer without adding a K-Cup
®
portion pack. The blue lights behind
the Brew Buttons on the LED Control Center will flash. Be sure to have a
mug or cup on the Drip Tray Plate and then press a Brew Button.
NOTE: After brewing a hot cocoa K-Cup, we recommend running a hot water
brew cycle without a K-Cup.
Purging the Brewer
If your Brewer has not been used for more than one week, you should purge
the water from the inner tank.
1. If there is water in the Water Reservoir, remove the Lid, then lift Reservoir
straight up and away from Brewer. Discard water, rinse and refill with
water. Place the Water Reservoir back on the Brewer and replace the
Lid. (If there is no water in Reservoir, simply refill.)
2. Be sure the Brewer is turned on. Raise and lower the Handle on the
Brewer without inserting a K-Cup and wait until the red light next to
‘HEATING’ turns off.
3. The blue lights behind the Brew Buttons on the LED Control Center
will flash. Be sure to have a mug or cup on the Drip Tray Plate and then
press a Brew Button.
4. Repeat steps 2 and 3 two more times to completely purge water
from inner tank.
If you are experiencing any problems with your Brewer, please contact
Customer Service at 1.866.901.BREW (2739).
9