Filter
Top Products
B3000 SERVICE MANUAL
60-200807-000, REV C 13
4. Appliance Safety
When using electrical appliances, basic safety precautions must always be followed. Read all
instructions before using this brewer. Failure to comply with the instructions risks equipment
damage, fire or severe bodily injury.
WARNING: ALWAYS UNPLUG THE BREWER BEFORE SERVICING
• To reduce the risk of fire or electric shock, do not expose this brewer to rain or moisture.
• Do not immerse the brewer in water, as this could lead to electric shock, electrical and or
mechanical malfunctions.
• Do not use brewer for other than its intended use.
• Both the Cold Water Tank (CWT) and the Hot Water Tank (HWT) should be drained
prior to moving the B3000 from one location to another.
POWER SUPPLY
Only use a correctly wired and grounded 120VAC / 60Hz socket outlet rated for at least 15A
service. It is recommended that a Ground Fault Circuit Interrupter (GFCI) outlet be used.
• Avoid sharing the same outlet with other appliances.
• Your brewer is equipped with a molded, grounded three prong polarized AC line plug.
This is a safety feature. Do not defeat the safety purpose of the polarized plug.
• The system requires a 3-wire grounded outlet with a minimum of 15 amp service.
• Do not use extension cords with this brewer.
5. Brewer Setup
Unpacking Instructions
WARNING: Keep all plastic bags away from children.
1. Place Brewer box on its side on a large steady surface such as a table, countertop, or on the
floor. Open the box from the end that says UP.
2. Remove the Quick Start Guide, Use & Care Guide and other literature.
3. Reach into the box and grasp the poly foam packing that protects the Brewer.
4. Carefully pull the poly foam toward you and out of the box. Remove the poly foam
packaging material surroundings the brewer.
5. Place the brewer upright on a flat, steady surface.
6. Remove the plastic bag.
7. It is recommended that you save all packing materials and shipping carton in the event that
the brewer must be shipped or stored.