Filter
Top Products
B3000 SERVICE MANUAL
60-200807-000, REV C 43
8. Disconnect the multi colored wire harness located to the left of the Hot Water Valve and the two
wires on the Hot Water Valve solenoid. There is no polarity for these wires.
9. Disconnect the Vent tube from the venting nipple on the left hand side of the module area.
10. The Puncture Mechanism Module can now be removed from the brewer.
NOTE: When reinstalling the new module connect the Hot Water Vent hose to the vent nipple
FIRST, and then connect the wire harness and two solenoid wires before you place the module on its
support post making sure that they are secure and tight. Reconnect the remaining hoses.
11. Conduct a BIT test (see appendix VII on page 85) to insure the proper function of the brewer.