Filter
Top Products
B3000 SERVICE MANUAL
60-200807-000, REV C 51
8. Loosen fully the two screws that secure the Cold Water Tank to the chassis. They are captive
screws so they will NOT come out completely.
9. While gently holding the plastic tube from the Inlet Valve out of the way, remove the Cold
Water Module.
10. Install the new module; connect all of the appropriate connections, hoses and wires making sure
that they are secure and tight.
11. Conduct a BIT test (see appendix VII on page 85) to insure the proper function of the brewer.