Filter
Top Products
B3000 SERVICE MANUAL
60-200807-000, REV C 15
6. User Interface & Brewing Procedure
(Without a coin changer)
IMPORTANT: The brewer must be primed for its first use as set forth below. If Spanish or
French are going to be the primary language, then you must go to the MENU MODE (page 19)
and change the language before proceeding with the priming of the brewer. The brewer’s default
language is English.
NOTE: The B3000 power switch uses “0” for OFF and “
-” for ON.
Priming the Brewer
1. Place a cup or mug (8 oz Min) on the Drip Tray Plate (if not done, the brewer will prompt for the
cup or mug later in the priming sequence)
2. Press power switch to the “
-” position.
3. At power up, the brewer will display the following:
KEURIG B3000 BREWING SYSTEM
4. The display will automatically change to:
CONNECT WATER AND THEN PRESS FLASHING BUTTON
5. After water is connected, then press button.
6. The display will read:
PRIMING
7. Then automatically change to:
PRIMING
HEATING - PLEASE WAIT
8. After heating has taken place the display will read:
PLACE YOUR CUP
OR SELECT ‘ CONT ‘
9. After placing the cup the screen will read:
PRESS FLASHING BUTTON
TO CONTINUE
10. Press the flashing button and conduct a water only brew.
11. After the water only brew is complete the unit is primed and the following will be displayed:
PRIME COMPLETE
12. Next you will read:
HEATING – PLEASE WAIT
13. After heating has taken place the screen will show: (With a Coin Changer)
READY – CHOOSE K-CUP READY
LIFT HANDLE DEPOSIT XXX CENT