Filter
Top Products
7
Refrigerator features
Utility compartment
The utility compartment can be placed in any position on the
refrigerator door.
To remove:
1. Grasp both ends of compartment.
2. Lift compartment up and pull out.
To replace:
1. Insert compartment hooks into ladder slots on both sides of
refrigerator door.
2. Push compartment down to lock into place.
Door bins
Door bins hold two-liter bottles and can be placed in any
position on the refrigerator door.
To remove:
1. Grasp door bin.
2. Lift door bin up and pull out.
To replace:
1. Insert door bin hooks into ladder slots on both sides of
refrigerator door.
2. Push door bin down to lock into place.
Gallon Door Bin
The gallon door bin holds several gallon-sized containers and
can be placed in any position on the refrigerator door.
Note: Positioning the gallon door bin directly across from an
interior shelf or covered storage bin will prevent the refrigerator
door from closing and could cause damage to bins and shelves.
To install:
1. Insert the attachment brackets into the adjustment slots on
the door.
2. Push down on the bin to secure tabs.
3. If necessary, adjust interior shelves to allow for milk jugs and
tall beverage containers stored in the gallon door bin.
SpillClean™
glass refrigerator shelves
Adjust the shelves to match the way you use your refrigerator.
IMPORTANT: Do not clean glass shelves with warm water
when they are cold. Shelves may break if exposed to sudden
temperature changes or impact. For your protection, tempered
glass is designed to shatter into many small pebble-sized
pieces. This is normal.
To remove:
1. Tilt shelf up at front and lift shelf up at back.
2. Pull shelf straight out.
IMPORTANT: Glass shelves are heavy. Handle them carefully.
To replace:
1. Guide the rear shelf hooks into slots in the shelf supports on
the back of the refrigerator wall.
2. Tilt shelf up at front until hooks drop into slots. Lower front of
shelf to level position.
3. Check the stability of the shelf to be sure hooks have been
inserted properly.