Filter
Top Products
Option 2: Garbage disposal connection
1. Route the drain hoses as shown and press the hoses
into the drain hose support.
2. Decide if the drain hoses need to be trimmed. If they do,
trim them.
3. Slip a wire clip over each drain
hose. Push the hoses into the
drain hose connector firmly,
5 clicks.
4. Position the wire clips between
the two positioning ribs on the
drain hose connector.
5. Attach the drain hose connector to the garbage disposal
using the supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with
a #8 Phillips head screw at the height shown below.
NOTE: The drain hose connector must not support the
weight of excess hose length. Keep hoses as fully extended
as possible.
Option 3: Air break connection
1. Route the drain hoses as shown.
2. Decide if the drain hoses need to be trimmed. If they do,
trim them.
3. Slip a wire clip over each drain
hose. Push the hoses into the
drain hose connector firmly,
5 clicks.
4. Position the wire clips between
the two positioning ribs on the
drain hose connector.
10
Install the Drain Hose
Option 1: Sink drain waste tee connection
1. Route the drain hoses as shown and press the hoses into
the drain hose support.
2. Decide if the drain hoses need to be trimmed. If they do,
trim them.
3. Slip a wire clip over each drain
hose. Push the hoses into the
drain hose connector firmly,
5 clicks.
4. Position the wire clips between
the two positioning ribs on the
drain hose connector.
5. Attach the drain hose connector to the waste tee using
the supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with
a #8 Phillips head screw at the height shown below.
NOTE: The drain hose connector must not support the weight
of excess hose length. Keep hoses as fully extended as
possible.
drain hose
support
water supply
waste
waste tee
27-1/2" – 32-1/4"
(70 cm – 82 cm)
waste
garbage
disposal
valve
water supply
8" (20.3 cm) min. bend
radius from valve
27-1/2" – 32-1/4"
(70 cm – 82 cm)
6" (15.2 cm)
minimum
wire clip
wire clip
drain hose
connector
wire clip
wire clip
drain hose
connector
wire clip
wire clip
drain hose
connector
drain hose
support
Option 2: Top attachment
1. If the top attaching brackets are used, open the top drawer
slightly.
2. Screw the top attaching brackets to the underside of the
counter with two #8 Phillips head screws.
IMPORTANT: The top attaching brackets can accommodate
a maximum 3/4" (19 mm) vertical gap.
3. Close the top drawer.
top attaching bracket
YD40643/8546448_E_non-RFI 10/1/04 9:42 AM Page 10