Filter
Top Products
5
Garbage Disposer:
If you plan to install a garbage disposer, an additional separate
120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply is
required.
INSTALLATION INSTRUCTIONS
Prepare Cabinet Opening
1. Prepare the cabinet opening by applying self-adhesive
moisture protection tape to the dry dust-free underside
of the countertop.
2. Turn off water supply.
3. Decide which attaching tabs to use to secure the dishwasher.
The four side attaching tabs are recommended.
4. If the countertop material permits and the optional top
attaching brackets will be used, install them now.
Slide the brackets under the raised tabs. Using the flat side of
the side cutting pliers, lightly tap the brackets into place.
Make sure the locking tabs on the brackets are completely
passed through the raised tabs on the dishwasher.
5. If using the factory-installed power cable and plug, go to
“Electrical connection” section, Option: 1: Power Supply Cord
Method.
If direct wiring the dishwasher, go to “Electrical connection”
section, Option: 2: Direct Wiring Method.
moisture
protection tape
tape
1/2" (12.7 mm) from
front of countertop
countertop
mounting
bracket
locking tab
raised tab
Electrical Connection
Option 1: Power Supply Cord Method
1. Place cardboard or other protective covering on the floor in
front of cabinet opening. Place the dishwasher on covering.
2. Begin to route the hoses and power supply cord through the
utility hole in the cabinet.
3. Push dishwasher partway into the opening.
IMPORTANT: Push against the outside edges of drawers as
shown. Do not push against the center of the drawers.
WARNING
Tip Over Hazard
Do not use dishwasher drawer until inside cabinet
opening.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
Recommended ground method
This appliance must be grounded. This appliance is equipped
with a power supply cord having 3 prong ground plug. To
minimize possible shock hazard, the cord must be plugged into a
mating prong ground-type outlet, grounded in accordance with
local codes and ordinances.
YD40643/8546448_E_non-RFI 10/1/04 9:41 AM Page 5