Filter
Top Products
14
Preparation of espresso and coffee
Using coffee beans
You have already prepared the appliance. When the rinsing process is
finished, the following lamps will glow: “rinse”; “1 cup normal”;
“1 cup strong”; “2 cups”; “coffee-meal”.
■ Place one or two cups beneath the espresso
delivery pipe. You can raise or lower the
delivery pipe to suit the size of your cups (15).
■ Select the desired or or key (15).
The mill will grind the required amount of coffee-
meal. (Remember that you can change the
degree of coarseness during the actual grinding).
Following this, the coffee-meal will be moistened with a little water for the pre-
brew. After a short pause, the proper brewing operation will be carried out.
Note: If you press the key, you will obtain one cup of strong espresso
or coffee. The simultaneous preparation of two cups of strong espresso or
coffee is not possible.
If you accidentally actuate the key, you can cancel the action by
pressing the or the key. Place a receptacle beneath the
espresso delivery pipe, however, as a little water will run out.
Using ready-ground coffee-meal
You have already prepared the appliance. When
the rinsing process is finished, the following
lamps will glow: “rinse”; “1 cup normal”;
“1 cup strong”; “2 cups”; “coffee-meal”.
■ Open the lid of the coffee feed funnel and put
in one or two level measuring spoonfuls of
espresso- or coffee-meal (16).
■ Press the key (17a).
The “coffee-meal” indicator will blink and the
“1 cup normal” and “2 cups” indicators will glow.
■ Now select and press the or the as
required (17b).
Caution!
Do not put more than two level
measuring spoonfuls into the feed funnel.
The funnel is not a storage receptacle.
Neither should you put in less than one level
measuring spoonful, otherwise the espresso
or coffee delivery will be automatically
interrupted. Use only ground coffee-beans
and not instant coffee or drink powders.
appliance
indicator(s)
15
16
17a
17b