Filter
Top Products
A delight in freshness
WFI1051 / EWTN 2956
18
INSTALLATION
LBR034
Figure 16
Only install the winecooler/freezer in a stable kitch-
en cabinet that has been properly aligned.
- Mount and fix the handles, depending on your
model and choice.
Unpacking
Unpack the installation kit and check with the pro-
vided parts list if all parts are included.
The part numbers given in the parts list are identical
to the numbers in the respective fi gures.
For installation you will need the following tools:
Included:
- Star Key Torx® 15
- Star Key Torx® 20
- Star Key Torx® 25
- Socket Wrench 8 mm
- Open-end Wrench 10 mm
Not in package:
- Phillips (star) screwdriver
- Level
- Ruler
Figure 16: Installation with Ventilation Grille Set:
1. Screw the installation frame at the top (1) onto
the appliance with screws (2).
2. Place the ventilation grille (3) on this, align it in
the center and secure at the front from under-
neath.
3. Slide brackets (4) onto the side installation
frames (5) from above and below.
4. Using the frame (5), screw the brackets onto
the side wall*.
5. Slide the side installation frames (5) upwards
until they are in contact with the underside of
the ventilation grille.
6. Secure the side frames with the adhesive sec-
tion (7) to prevent them from sliding down.
Remove the protective film and affix the adhe-
sive sections over the upper brackets on the
handle and hinge sides.
* Depending on model and options