Filter
Top Products
A delight in freshness
WFI1051 / EWTN 2956
24
ICEMAKER
3. Open the shut-off valve for the water supply
and check the entire water system for leaks.
Before the appliance is used for the first time a
licensed plumber should bleed air from the sys-
tem.
4. Insert the electrical plug for the combined appli-
ance into the electrical outlet (Figure 23).
5. Move the appliance into final position in the
room.
Figure 23
Connection to the Water Supply
1. Install the shut-off valve, water filter and auto-
matic shut-off device as required.
Note
The solenoid valve is located at the rear of
your unit.
2. Place a 1/4" OD copper tubing between the
shut-off valve and solenoid valve. Make sure
there is approximately 30" (70 cm) of excess
tubing behind the unit for easy connection.
IMPORTANT
The solenoid valve has a Metric R3/4 male
connection.
A R3/4(metric) to a 1/4" OD adapter and
cable clip are supplied with the icemaker.
Figure 24: Remove the cover cap (4) from
the solenoid valve (1). Install the connection
bracket (2) with sealing ring (6) on the solenoid
valve (1). Attach the copper tube to the connec-
tion bracket (2). Secure the copper tube (3) to
the appliance using the cable clip (5).