Filter
Top Products
CounterTop - 1300 Series Ops Manual
12
CONVEYOR REMOVAL
CONVEYOR DISASSEMBLY FOR CLEANING
Pull conveyor out the right end. Place on table or work surface.
CONNECTING
LINKS IN
FOUR PLACES
1. Remove extension shelves (if applicable).
2. Push coupling away from drive lugs.
3. Remove conveyor from oven cavity.
4. Reassemble in reverse order. 5. Install extension shelves (if applicable).
1. Locate connecting links on the conveyor belt, turn belt to
place the links on the top left end of the conveyor –
approximately 8” (203 mm) from the shaft.
2. You can easily remove the connecting links by grasping
them with a pair of pliers and slipping the eye of the
connecting link over the wire of the other links.
3. Carefully pull out the belt, rolling it up as you go. After
you have it removed it may be placed in a pan of
detergent solution to soak. Rinse with clean water.
Also, notice the direction of the opening on the other links.
The belt will have to be reinstalled with the opening facing
the same way.
CORRECT
INCORRECT