Filter
Top Products
CounterTop - 1300 Series Ops Manual
9
COUNTERTOP MOUNTING INSTRUCTIONS
Position the oven on the countertop and carefully mark the position of the rear legs. Remove the oven from the
countertop and position the mounting rings so that the large (center) hole is where the legs of the oven were
marked. Mark the position of the two small holes and remove the mounting rings. Install per instruction 1 or 2
below.
1. When installing on a heavy stainless steel countertop, use the four #10-32 x 3/8” machine screws. Use a .159”
diameter drill (#21) and drill through the countertop. Use a 10-32 tap through the holes. Using a screwdriver,
mount the rings in position. Set the oven on the countertop so that the rear legs are in the larger holes in the
mounting ring.
2. When installing on a plywood or composition board countertop, use the four #10 x ½” sheet metal screws. Use
a .169” diameter drill (#18) and drill at least ½” into the countertop. Using a screwdriver, mount the rings in
position. Set the oven on the countertop so that the rear legs are in the large holes in the mounting rings.
REAR
FRONT
Leg location for
Impinger
®
Countertop Oven