Filter
Top Products
MAINTENANCE
Electrical Connection Leveling Legs
Appliances which require electrical power are equipped Some floors are not level. For proper baking, your range
with a three-prong grounding plug which must be must be level. The leveling legs are located on each
plugged directly into a properly grounded three-hole corner of the base of the range. Level the range by
120 volt electric'a] outlet, turning the legs.
If an ungrounded, two-hole or other type electrical
outlet is encountered, it is the personal _ _ [ [d [ _
responsibility of the appliance owner to have
receptacle replaced with a properly grounded
three-hole electrical outlet. The three-prong
grounding plug is provided for protection against shock ((_)
hazards. Do not cut or remove the third grounding
prong from the power cord plug.
O
Always disconnect power to appliance before servicing. Light Replacement
Before replacing the oven or panel light bulb,
Proportional Valve Adjustment disconnect power to range. Be sure tim bulb and
range parts are coo/. Do not touch a hot bulb with a
The WARM setting should produce a stable flame when damp cloth as the bulb may break.
turning the knob from HIGH to WARM. The flame
should be 1/8 inch or lower and nmst be stable on all To Replace Panel Light (select models)
ports. Grasp the top trim of' the back panel with your tbmnbs
under the front edge and pull outward while lifting the
To adjust: Operate burner on HIGH for about 5
minutes to preheat burner cap. Turn knob back to trim. Remove the bulb and replace it with an 18 watt
WARM; remove knob, and insert a small screwdriver fluorescent tube. Snap the top trim back into place and
into the center of the valve stem. Adjust flame size by restore the power. Reset the clock.
turning adjustment screw in either direction. Flame
ports.mUstbeiftlame°fsufficientadjustmentsize ist°J}eeded,bestableadjuston alloNLybUrneron _ .... ,__
F-
the WARM setting. Never adjust flame size on a higher
setting.
To Replace Oven Light
Carefully unscrew the lens cover (select models) with a
&y potbolder. "very carefully remove the bnlb with the
potbolder. Replace witb a 40 watt appliance bulb.
Reconnect the power to the range and reset the clock.
PAGE 16