Filter
Top Products
Disassembly Procedures
WARNING
!
©2004 Maytag Services 16023219 15
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and shut off gas
supply before following any disassembly procedure.
Removing and Replacing Unit
1. Turn off gas and power supply to the oven.
NOTE: To avoid property damage, place a protective
covering on the floor.
2. Slide unit forward, out of the installation position.
3. Disconnect or unplug the power cord leading from
unit to junction box or outlet depending on
connection.
4. Turn off gas supply and disconnect from main gas
line.
5. Reinstall oven, using Installation Instructions.
Knob Bezel(s)
1. Turn off gas and power supply to the oven.
2. Remove surface burner knobs from control panel, by
pulling knobs straight off.
3. Remove oven control knobs from control panel.
• Rotating knob to gain access to set screw.
• Loosen set screw on knob.
• Rotate knob to "OFF" position and remove.
4. Remove screws securing knob bezel to control
panel.
5. Replace component and reverse procedures to
reassemble.
Control Panel, Rocker Switch(es), and
Indicator Light(s)
1. Turn off gas and power supply to the oven.
2. Remove surface burner knobs from control panel, by
pulling knobs straight off.
3. Remove oven control knobs from control panel.
• Rotating knob to gain access to set screw.
• Loosen set screw on knob.
• Rotate knob to "OFF" position and remove.
4. Remove screws securing control panel cover to
chassis.
5. Roll top portion of control panel cover downward to
gain access to components.
6. Disconnect and label wire terminals from rocker
switches.
7. Slide indicator lights to the side to release from
holders.
NOTE: Once an indicator light is released from the
holder the front lens will fall out.
Surface Burner Micro Switch(es)
1. Turn off gas and power supply to the oven.
2. Release control panel cover, see "Control Panel"
procedure, steps 1 through 5.
3. Disconnect and label wire terminals from micro
switch located on the burner valve.
4. Remove micro switch from burner valve, by pulling
switch from burner valve.
5. Replace component and reverse procedure to
reassemble.
Surface Burner Valve(s)
1. Release control panel cover, see "Control Panel"
procedure, steps 1 through 5.
2. Remove micro switch from burner valve.
3. Disconnect gas line from surface valve.
4. Unscrew burner valve from manifold pipe.
NOTE: Some additional components maybe required to
be disconnected or removed. This will allow
access for valve to be unscrewed from manifold
pipe.
5. Replace component and reverse procedure to
reassemble.
NOTE: When installing valve, use pipe dope
compound. Perform gas leak test to ensure unit
will not leak and unit operates properly.
Oven and Surface Broiler Infinite Switch
1. Turn off gas and power supply to the oven.
2. Release control panel cover, see "Control Panel"
procedure, steps 1 through 5.
3. Disconnect clips securing sensor bulb.
4. Remove screws securing switch to mounting
bracket.
5. Disconnect and label wire terminals from switch.
6. Slowly guide sensor bulb from unit.
7. Replace component and reverse procedures to
reassemble.
NOTE: Perform gas leak test to ensure unit will not leak
and unit operates properly.