Filter
Top Products
Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and shut off gas
supply before following any disassembly procedure.
WARNING
!
18 16023219 ©2004 Maytag Services
Door Removal
1. Remove bottom kick plate.
• Pull outward on bottom portion of the kick plate to
release.
• Push upward on kick plate to release and remove
from unit.
2. Release tension spring on door hinge, by completely
removing nut from eyebolt.
3. Remove eyebolt from hinge hanger.
4. Remove hinge hanger from door hinge.
NOTE: Once hinge bolts are removed, oven door will
fall. Secure oven door before removing hinge
bolts.
5. Remove bolts securing door hinge to chassis.
• Located behind oven door hinges is a metal
spacer.
6. Remove door from unit.
Door Disassembly
1. Remove oven door, see "Door Removal" procedure.
2. Place door on a protected surface to prevent
damaging the oven door.
3. Remove screws securing the bottom and sides of the
door.
NOTE: Located on the side screws is a nut used a
spacer between outer shell and inner door
assembly.
4. Carefully pry the bottom corners outward on outer
shell to allow outer shell to bypass door hinges.
5. Remove screws securing door handle and replace if
necessary.
6. Remove screws securing outer door glass and
replace if necessary.
7. Remove screws securing inner door glass brackets
and replace glass if necessary.
8. remove nuts securing inner door wrapper to inner
door.
9. Remove insulation to gain access to inner window
assembly.
10.Remove nuts securing inner window assembly and
replace if necessary.
11.Replace component and reverse procedures to
reassemble.
Gas Regulator
1. Turn off gas and power supply to the oven.
2. Remove surface module, located on the right side of
unit. See module type for removal procedures.
NOTE: Complete disassembly of module may not be
required to gain access to gas regulator.
3. Disconnect all gas lines from gas regulator.
4. Replace component and reverse procedure to
reassemble.
NOTE: When installing, use pipe dope compound.
Perform gas leak test to ensure unit will not leak
and unit operates properly.
Manifold Pipe
1. Turn off gas and power supply to the oven.
2. Release control panel cover, see "Control Panel"
procedure, steps 1 through 5.
3. Remove micro switches from all surface valves.
4. Cut plastic ties securing wiring to manifold pipe.
5. Disconnect gas lines, at the union from manifold
pipe.
6. Remove bolts securing gas manifold to burner box.
7. Remove surface valves from manifold pipe.
8. Replace component and reverse procedure to
reassemble.
NOTE: When installing valve, use pipe dope
compound. Perform gas leak test to ensure unit
will not leak and unit operates properly.