Filter
Top Products
Disassembly Procedures
WARNING
!
©2004 Maytag Services 16023219 17
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and shut off gas
supply before following any disassembly procedure.
Broil Burner and Ignitor
1. Shut off power and gas supply to unit.
2. Release control panel cover, see "Control Panel"
procedure, steps 1 through 5.
3. Remove surface modules located over broiler.
4. Remove screws securing heat reflector.
5. Disconnect gas line from broiler.
6. Remove screws securing broiler ignitor to oven
cavity.
7. Remove screws securing broiler to oven cavity.
8. Loosen screws securing rear broiler gaurds to oven
cavity.
9. Remove screws securing front of broiler gaurds to
oven cavity.
10.Slide front portion of broiler gaurds outward to gain
access to broiler.
11.Remove broiler from oven cavity.
12.Replace component and reverse procedure to
reassemble.
Bake Gas Valve(s)
NOTE: Located behind kick plate area.
1. Shut off power and gas supply to unit.
2. Remove kick plate from under oven needing
servicing.
3. Disconnect and label wire terminals from gas valve.
4. Disconnect fuel lines connected to gas valve.
5. Remove screws securing gas valve bracket to unit
chassis.
6. Replace component and reverse procedure to
reassemble.
NOTE: Perform gas leak test to ensure unit will not leak
and unit operates properly.
Broiler Gas Valve(s)
NOTE: Located in the surface burner box area.
1. Shut off power and gas supply to unit.
2. Release control panel cover, see "Control Panel"
procedure, steps 1 through 5.
3. Remove surface module top portion from surface
module to gain access to gas valve.
4. Disconnect and label wire terminals from gas valve.
5. Disconnect gas lines connected to gas valve.
6. Remove screws securing gas valve bracket to unit
chassis.
7. Replace component and reverse procedure to
reassemble.
NOTE: Perform gas leak test to ensure unit will not leak
and unit operates properly.
Backgaurd
NOTE: This procedure requires removal of unit from
installation position.
• Remove screws securing panel to backgaurd,
located on the back of the unit.
Top Side Panel
1. Remove top portion of module from unit, located next
to the side needing replaces.
2. Remove screws securing top side panel to the
chassis.
3. Replace component and reverse procedure to
reassemble.
Side Panel
NOTE: This procedure requires removal of unit from
installation position.
1. Remove top side panel, see "Top Side Panel"
procedure.
2. Remove screws securing top, bottom, and rear of
side panel to the chassis.
3. Pull outward on the back of the side panel and slide
panel to the rear to release side panel from the
chassis.
4. Replace component and reverse procedures to
reassemble.