Filter
Top Products
Oven Light Storage Drawer
[ACAUTIONS: ACAUTION:
• Disconnect power to rangebefore replacing light bulb. • Do not store plastic, paper products, food or
flammable materials in this drawer.The drawer
• Use a dry potholder to prevent possible harm to hands may become too warm for these items when the
when replacing bulb. oven is in use.
• Be sure bulb is cool before touching bulb.
The storage drawer can be removed to allow you to
• Donottouchhotbulbwithadampclothasthismaycause clean under the range.
the bulb to break. To remove:
1. Empty drawerandpull out to the firststop position.
To replace oven light bulb: 2. Lift upthe frontof the drawer.
1. Remove light bulb. 3. Pull out to the second stop position.
2. Replace with a 40 watt appliance bulb.
4. Grasp sides and lift drawer up and out.
3. Reconnect power to range. Reset clock.
To replace:
1. Fit the ends of the drawer glides into the rails inthe
Leveling Legs range.
A CAUTION 2. Lift up front of drawer and gently push in to the first
stop position.
• Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor to prevent the range from 3. Lift drawer up again and push until drawer is closed.
accidentally tipping.
Therange should be leveled when installed. If Convenience Outlet
the range is not level, turn the plastic leveling IIi vi'_ (Canadian models only)
legs, located at each comer of the range, until )/i_-. 'i II
range is level. __,_ The convenience outlet is
located on the lower left
side of the backguard. It is
___ useful for small appliances
_ _ ANTI-TIPBRACKETSUChaswaffle irons. CmCU,TBREAKER0
When using the outlet be SWITCH
V_%LEVELING LEG sure the appliance cord does not rest on or near the
surface element. If the surface element is turned on,
the cord and outlet will be damaged.
The convenience outlet circuit breaker may trip if the
small appliance plugged into it exceeds 10 amps. To
reset the circuit breaker, press the switch located on
the lower edge of the backguard. (See illustration.)
16