Filter
Top Products
Controls at a Glance...............................
Electronic Clock and Oven Control (select models)
i BAKE
__ BROIL
NOTE: The display will flash when the appliance is first connected to power or if power is interrupted. The display
will stop flashing once the time-of-day clock has been set. The BAKE, BROIL and TIMER indicators light when the
function pad is pressed.
CANCEL Pad Setting the Timer
Press this pad to cancel all operations except the clock and The timer can be set from one minute (:01) up to 9 hours
timer, and 50 minutes (9:50). Time will be displayed in minutes
and not in seconds. THE TIMER DOES NOT CONTROL
• and V Pads THE OVEN.
1. Press the TIMER pad.
Press and tap, or press and hold, these pads to enter the de- • :00 and the TIMER indicator light will appear in the
sired time, temperature, or to select HI or LO broil, display. The colon will flash.
2. Press the • or • pad until the desired time is displayed.
BAKE Pad • The timer will begin as soon as the time is set.
• The flashing colon indicates that a timing operation
Use for baking or roasting, is in progress. The colon will not flash if the time of
1. Press BAKE pad. day or oven temperature is displayed.
2. Press • or • pad to set the oven temperature. • The timer countdown will be displayed unless an-
See page 9 for additional information, other function is programmed after setting the timer.
• A single beep signals the end of the operation.
BROIL Pad "END" will appear in the display. If the time of day
or oven temperature is displayed "END" will not
Use for top browning and broiling, appear.
1. Press BROIL pad. • A short beep will sound every 30 seconds for five
2. Press • or • pad for HI or LO broil, minutes to remind you that the operation has completed.
See page 12 for additional information. 3. If desired, press the TIMER pad and the time of day
will reappear in the display during a timing operation.
Setting the Clock To cancel the timer operation: Press and hold the
1. If the display is flashing, press the CLOCK pad to stop the TIMER pad for three seconds.
flashing, then press the CLOCK pad again.
• If the colon is not flashing, press the CLOCK pad. Additional Information
• The clock time cannot be set if the control is programmed
for abake, broil or timing operation. • A beep will sound each time a function pad is pressed.
There is no beep for the • or • pad.
2. Set the correct time of day using the A and • pads. IftheA • If a fault code (example: F2) is displayed and beeps
or • pad is not pressed within 30 seconds, the program will sound, press the CANCEL pad. If the fault code contin-
cancel. Press the CLOCK pad and begin again, ues, see page 17.
5