Filter
Top Products
Oven Cookin
Oven Control
Timer
Bake Broil Clock Timer
NOTE:Thedisplay will flashwhen the appliance isfirst connected topower or ifpower isinterrupted. Thedisplay willstop flashing
once time-of-day clockhas been set.The Bake,Broiland Timer indicators light when function is pressed.
Cancel Pad • The clocktime cannot be set if the • A single beep signals the end of the
control is programmed for abake, operation. "END" will appear in
Press to cancel all operations except the broil or timing operation, the display. Ifthe time of day or
clockand timer.
2. Setthe correcttimeofdayusing the A oven temperature is displayed
and • pads. Ifthe • or • pad isnot "END" will not appear.
• and • Pads pressed within 30 seconds, the pro- • A short beep will sound every 30
gram willcancel. Press the Clock pad seconds for ten minutes to remind
Press and tap, or press and hold, to enter and begin again, you that the operation has corn-
the desired time,temperature, orto select pleted. "END" remains in the
HI or LO broil.
display until Cancel pad is
Setting the T/mer pressed.
Bake Pad Thetimer canbe setfromoneminute (:01) If desired, press the Clock pad
up to 11 hours and 50 minutes (11:50). and the time ofday will reap-
Usefor baking or roasting. Time will be displayed in minutes and
pear in the display during a
1. Press Bakepad. not inseconds. THE TIMER DOESNOT timing operation.
2. Press • or • pad to set the oven CONTROL THEOVEN.
temperature. 3. Press the Cancel pad and the time of
1. Press the Timer pad. day will reappear in the display.
Seepage 6 for additional information. • :00will light and the Timer indica-
tor light will flash in the display. To cancelthe timer operation: Press and
Broil Pad 2. Pressthe• or • pad until the desired hold the Timer pad for several seconds.
time is displayed.
Use for top browning and broiling.
1. Press Broilpad. • The timer will begin as soon as the Additional Information
2. Press • or • pad for Hi or Lobroil, time isset.
• The flashing colon indicates that a • A beep will sound each time a flmc-
Seepage 6 for additional information, timingoperationisinprogress. (The tion pad is pressed. There is no beep
colon will not flash if the time of for the • or • pad.
Setting the Clock day or oven temperature is • If a fault code (example: F2) is dis-
displayed.) played and beeps sound, press the
1. If the display is flashing, press the • Thetimer countdown will be Cancel pad. If the fault code contin-
Clock pad to stop the flashing, then displayed unless another function ues, see page 10.
press the Clock pad again, is programmed after setting the
• Ifthe colonisnot flashing,pressthe timer.
Clock pad.