Middleby Marshall PS540 (Double) Oven User Manual


 
30
SECTION 4
MAINTENANCE
I. MAINTENANCE - DAILY
A. Exterior
Everyday you should clean the outside of the oven with a
soft cloth and mild detergent.
WARNING
Never use a water hose or pressurized steam
cleaning equipment when cleaning the oven.
B. Cooling Fan
1. TWO COOLING FAN GRILLES AT THE REAR OF
EACH OVEN CONTROL COMPARTMENT MUST BE
CLEANED DAILY - Clean grilles with a stiff nylon type
brush.
2. Check the air intake of the cooling fan daily. The best
time to check is right after starting the oven.
IMPORTANT NOTE
The cooling fan operates when the blower switch
is turned to “ON” (“I”). It must operate to keep the
electrical control cabinet below 140°F (60°C).
WARNING
IF FAN BLADE IS NOT ROTATING, BROKEN,
OR FAN ASSEMBLY IS MISSING FROM MAIN
BLOWER MOTOR SHAFT, DO NOT OPERATE
OVEN. REPLACE COOLING FAN BLADE
BEFORE OPERATING OVEN. Serious damage
could be done to the burner blower motor and/or
solid-state electrical components if oven is
operated while cooling fan is not running or vent
grille is plugged.
3. Using a stiff nylon brush clean control compartment
vent grille. Hot air from control compartment exits from this
grille.
C. Conveyor Belt (Figure 4-2)
Everyday, just after starting the oven, stand at the
unloading end of the conveyor, and with a brush, remove
food particles (crumbs, etc.) clinging to the conveyor belt,
brushing them into the crumb pan.
D. Crumb Pans (Figure 4-2)
Remove and clean the crumb pan at each end of the oven.
Each crumb pan can be removed by sliding it out, as
shown in Figure 4-2. Reinstall the crumb pans after
cleaning.
E. Window
The window can be cleaned daily while it is in place.
Figure 4-2. Conveyor Belt and
Crumb Pan Cleaning
Figure 4-1. Oven Cooling Fans
Cooling Fan Grille
Vent Grille
Cooling Fan Grille