Filter
Top Products
Securing pieces
To ensure stability, the dishwasher must
be fixed securely to the worktop (step
5). Two securing pieces are supplied
for this purpose.
^ Fit the securing pieces into the slots
on both the left and right hand sides.
Granite and marble worktops
:
With these worktops the dishwasher
must be securely screwed to neigh-
bouring units on the right and left hand
sides. For this you will require two spe
-
cial fixing brackets (these are included
in the accessory pack together with fit
-
ting instructions and screws).
Angle support
The angle support for the water drain
-
age hose at the rear of the dishwasher
can be turned.
^
Turn the angle support in the direc
-
tion of the on-site connection for the
drainage hose.
^
Push the dishwasher right back into
the recess. Ensure that the drain
hose, inlet hose and the electric ca-
ble are laid to reach the connection
point without any kinks.
Make sure that the left side of the re-
flector panel is sited above the
in-operation light in the dishwasher
control panel. To check, switch on
the dishwasher, select a programme
and close the door. The light is visi
-
ble when the dishwasher has been
aligned correctly.
If it does not light up re-align the
dishwasher in the niche.
Installation
10