Filter
Top Products
7.Matching the plinth facia of a
kitchen run
The plinth area of the dishwasher is
normally covered with a plinth run
matching the kitchen furniture.
The height (H) of the plinth facia in front
of the dishwasher depends on the
plinth return (R) and how much the
door front extends below the dish-
washer door (P).
^
Place the plinth facia directly in front
of the kitchen run but do not attach.
^
Carefully open the dishwasher door.
If the door front comes into contact with
the kitchen plinth when the dishwasher
door is opened the plinth facia in the
area behind the dishwasher door needs
to be cut to size.
^
To do this mark where the edge of the
door front comes into contact with the
plinth facia.
^
Cut the plinth facia to size along this
line.
^ Place the plinth facia in front of the
kitchen run again and check whether
the dishwasher door can be opened
fully.
If it cannot, trim the plinth facia again
until to the correct size is achieved.
^ Secure the plinth facia to the adja-
cent kitchen units in accordance with
kitchen furniture manufacturer’s in-
structions.
If your kitchen does not have a plinth
run matching the kitchen furniture, the
plinth area can be covered with a sepa
-
rate plinth kit, available at extra cost
(special accessory).
Installation
19