Filter
Top Products
Ventilation
The appliance can be placed directly
against a wall. To ensure sufficient
ventilation, the ventilation gaps must
not be covered over. The air inlet and
outlet must not be covered or blocked
in any way. They should be dusted on a
regular basis.
Installation
^
Remove the cable clip from the back
of the appliance.
^
Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
^ Carefully push the appliance into
position.
Niche floor
To ensure the safe installation of the
appliance and to guarantee its correct
functioning, the floor to the niche where
the appliance is to be installed must be
smooth and even.
It must be made of strong, rigid
material.
The appliance is extremely heavy when
loaded and for this reason it is
imperative that the floor it stands on is
able to bear its weight. If necessary the
advice of an architect or a structural
engineer should be sought.
The weight of the appliance when
empty is approx.120 kg.
When fully loaded, the weight of the
appliance is approx. 350 kg.
Aligning the appliance
^
To align the appliance, adjust the
front feet using the spanner supplied.
Levelling the appliance door
^
Make sure that you unscrew the
adjusting foot under the lower hinge
until it sits on the floor. Then unscrew
the foot by a further 90°.
Door opening angle limiter
The door opening angle limiter restricts
the opening angle of the appliance
door to 90°C. This may be necessary if
the appliance door hits an adjacent wall
when opened, for example.
The door opening angle limiter is
available from your Dealer or Miele.
Installation
53