Filter
Top Products
^
Switch the machine off and then back on again with the
master switch.
^
Buff the contacts a little, e.g. with fine glasspaper or emery
cloth.
^
If this fault message continues to appear, please call the
Miele Service Department.
. . . the machine does not rinse through when switched
on, even though the Automatic rinsing programme is set
to "On".
If the temperature of the machine is still above 60 °C, rinsing
cannot take place.
. . . water stopped flowing whilst programming in the
amount to use.
Water flow stops automatically when the maximum fill quantity
is reached. The maximum quantity is stored in memory.
There is insufficient water in the water container. The quantity
used previously was not saved to memory.
. . . there is water in the waste container.
This is not a fault. The water is left over from the brewing and
cleaning process.
. . . there is a lot of residual "coffee water" in the waste
container.
If the slide control for the grinder is set to very fine, too much
residual "coffee water" can be left in the waste container.
^
If a very fine grinder setting has not been set, call the Miele
Service Department.
. . . the descaling process was started by mistake.
The descaling programme cannot be cancelled once "ok" has
been selected. The programme has to be completed through
to the end. This is a safety measure to ensure that the
machine is fully descaled, and is important for the long-term
protection of the machine and to ensure it functions correctly.
Problem solving guide
72