Filter
Top Products
Installation
Please refer to the installation
diagram supplied with the machine.
Furniture and fittings installed near the
machine must be of a commercial
standard able to withstand the effects
of steam and condensed water.
The machine must be installed
correctly and levelled.
Any uneveness in the floor level can be
compensated for and the height of the
machine raised or lowered by adjusting
the four screw feet.
The machine can be installed in the
following ways:
–
Freestanding:
–
Slot-in or at the end of a row:
The machine can be installed adjacent
to other equipment or furniture or in a
recess at least 60 cm wide and 60 cm
deep.
–
Building under:
The machine should be positioned
under a continuous worktop or sink
drainer.
The niche must be at least 60 cm wide,
60 cm deep and 82 cm high.
If necessary the machine lid can be
removed as follows:
Open the door.
Remove the fixing screws on the left
and right hand sides using a cross
slotted screwdriver.
Pull the machine lid approx. 5 mm
forwards, lift upwards and remove.
Important for machines
without a
steam condenser:
The cabinet vent at the rear of the ma-
chine must be connected to an on-site
duct system.
Important for machines
with a steam
condenser:
To protect the underside of the worktop
against water ingress, the protective
foil (25 x 58 cm, self-adhesive) should
be stuck under the worktop in the area
of the steam condenser.
Installation
44