Filter
Top Products
Position and secure the machine
To ensure stability the machine must
first be aligned and then screwed to
the worktop.
Open the door. Through each of the
two holes in the front rim, left and
right, screw the machine to the front
edge of the continuous worktop.
Do not use silicone sealant to seal
the gaps between the machine and
any neighbouring units as this would
hinder ventilation of the circulation
pump.
Depending on the requirements for
building under, the following
kit can be
ordered from the Miele Spare Parts
Department:
Coverplate (protects the worktop)
The underside of the worktop is
protected from water ingress by a
stainless-steel plate.
Decor frame fitting kit
The machine front can be fitted with a
decor panel to match kitchen units.
The decor frame is supplied with its
own fitting instructions.
Installation
45