Filter
Top Products
Installing integrated "i" Dishwashers
Lay the door front with the rear side
facing upwards.
Using a pencil draw a vertical line
down the middle of the door to use
as a guide line.
Draw a horizontal guide line across
the door, at a distance from the lower
edge of the front panel equalling the
previously measured dimension “X” .
The fixing bracket is marked in the
middle
A
.
Lay the bracket on the rear side of
the door front so that the marks
A
in
the middle of the fixing bracket align
with the vertical guide line, and the
lower fixing holes of the bracket are
centrally positioned in the horizontal
guide line (see illustration). Use
strips of adhesive tape to hold the
bracket in this position.
Drill the fixing holes to a depth of
about 10 mm, using a 2.5 mm drill bit.
Secure the bracket to the door using
the screws supplied.
Double check for correct alignment
before building into the recess.
Installation integrated “i” Dishwashers
64