Filter
Top Products
The door can only be opened when:
–
the lab glassware washer is
connected to the electrical supply,
–
the red (“emergency cut-off") power
switch is in the I-ON position,
–
the I-0 On-Off button is pressed in,
and
–
no program is running.
The door on the clean side (G 7826)
can only be opened when:
– DESIN (disinfection) programs have
been correctly completed.
or
– the “Door locking" function is active
(see “Machine function - Door
locking" in the “Programming
Manual").
Opening the door
^
Press the 5 door button, hold the
door handle and open the door.
,
Do not touch the heating
elements (under the wide area filter)
during or directly after the end of a
program, you could burn yourself. If
the boiler has been programmed to
“BOILER READY", be particularly
careful of hot water and steam when
opening the door. Danger of burning
or scalding. The water inlet pipe to
the wash cabinet is located, as
viewed from the unclean side,
underneath the basket runner on the
left hand side.
To close the door
^ Lift the door upwards and push until
it clicks shut.
Opening and closing the door
15