Filter
Top Products
To check the programmed
water hardness:
Open the door.
Turn off the dishwasher.
Press and hold buttons b and d
while simultaneously turning on the
dishwasher. The “ON” indicator lamp
will light and the “
8
k” and c
lamps will flash.
If any other indicator lamps flash, turn
off the dishwasher and start again.
Depending upon what “Additional Fea-
tures” are currently programmed into
your machine, other indicator lamps
may also illuminate. These should be ig-
nored for the time being.
Press Touch pad c to check the
water softener setting currrenty stored.
If a water hardness between 20 and
220 ppm (mg/l) is stored, the indica-
tor lamp next to the corresponding
touch pad will illuminate (see the Pro-
gramming Table). If no lamp lights
up, a hardness level greater than
220 ppm (mg/l) was set. In this case:
Press the 2 button. The indicator
lamp that corresponds to the stored
hardness level will illuminate.
Turn off the dishwasher.
Water Softener
14