Filter
Top Products
Adjusting legs.
Adjust the rear legs until the top cor-
ner of dishwasher (above the ad-
justed leg) presses against the
countertop. Do not overstress the
countertop; slide skid provides 10:1
gear ratio!
To raise the machine - turn clockwise.
To lower - turn counter clockwise.
10 turns of slide skid screw produce
1 mm lift. A battery-powered screw-
driver could be used on the lowest
torgue setting.
Adjust the front leveling legs by
pushing on the foot using flat screw-
driver.
It is easier to adjust the screw feet if the
weight of the dishwasher is not bearing
down on them.
If possible tip the machine slightly.
For fine adjustments it may be
necessary to press against the cogs
of the feet with a screwdriver.
Screw the feet out until the dishwasher
is right up against the underside of the
countertop, to which it will be screwed
later. Ensure that the dishwasher
stands level and that the front of the
wash chamber is square to the door.
Make sure the machine presses the
countertop in all 4 corners.
Dishwasher installation
54