Filter
Top Products
Before attempting any repairs out-
lined on this page, first:
Press and hold the START/Stop
button until the Program Selection
indicator lamps light, then
Turn off the dishwasher using the
ON/OFF switch.
The wash cycle finishes too early
and the “Drain” Indicator lamp
flashes
– The drain hose is kinked.
– The drain pump or non-return valve
may be blocked – see “Cleaning and
care”.
The “Spray arm” indicator lamp
flashes
– The middle spray arm is obstructed
by an item in the basket.
Open the dishwasher door and
remove the obstruction.
– The spray arm jets are blocked - see
“Cleaning and care”.
Shortly after starting a program the
“Water intake” indicator lamp flashes
– The water shutoff valve is closed.
Open the valve. The dishwasher
should continue the program.
If the program does not continue:
Press the START/Stop button until
the Program Selection indicator
lamps light, then
Turn off the dishwasher using the
ON/OFF switch.
Start the program again - see
“Starting a program”.
– Too little water may be entering the
machine due to insufficient water
pressure.
– The intake hose filter is clogged -
see “Cleaning and care”.
The “Water Intake” indicator lights
during the “ENERGY SAVER” pro-
gram.
The “ENERGY SAVER” program re-
quires a water supply temperature of at
least 45 °C/115 °F. If the incoming
water is less than this temperature, the
“Water Intake” lamp illuminates (see
also “Program selection”). If your hot
water system has been used recently,
not enough hot water may have been
available to adequately clean the
dishes.
If necessary, repeat the program.
If the “Water Intake” lamp lights
again, select a different program.
Problem solving guide
46