Filter
Top Products
The water pressure must be between
4.5 and 145 psi (0.3 and 10 bar).
If the water pressure is too low the ma-
chine may not take in enough water in
the alloted time and the “Water Intake” in-
dicator lamp will flash.
If the water pressure is too high, a press-
ure reducer must be installed.
Existing plumbing:
If the standard 3/8" copper plumbing for
a dishwasher already exists with a com-
pression fitting and valve as pictured:
Cut the 3/8" copper tubing after the
valve.
Install the 3/8" compression to 3/4"
MHT (Male Hose Thread) adapter
(supplied with the machine), as illus-
trated.
Connect the inlet hose to the existing
valve/adapter assembly.
Electrical wiring and components
should not come into contact with
any plumbing fixtures or hoses.
Do not, under any circumstances,
cut the intake hose. If the hose is
cut, the dishwasher will not work,
you will have a water leak and you
could be injured. If the hose is too
long, coil it neatly and place it be-
hind the machine.
Plumbing
67