Filter
Top Products
3. Installing the Control panel
The control panel and hardware is packaged separately from the dishwasher. It
should be installed using the follwing procedure.
If a GDU decor kit is being used, (to
convert an “i” dishwasher to a “U” ver-
sion), the spacer bars
i must first be
removed and stored for possible use
in the future, (See the separate in-
structions for installing the GDU
decor kit). If the GDU kit is
not being
used, skip the following step.
To remove the spacer bars from the
control panel, place the panel on a
table, printed side up, and gently
push down on the spacer bars at a
point near the bottom of the control
panel. This will release the mounting
bolts from their slots.
Install the necessary spacer bars on
the control panel.
Place the large cap b on the
ON/OFF button.
Place the two small caps with one
straight edge
c on to the “+” and
“–” buttons. The straight edges must
face each other.
Place the 12 small oval caps d onto
other button.
Place the seal e in the groove on
the rear of the ventilation grille
f,
then push the ventilation grille into
the metal backing plate.
Position the control panel g over the
backing plate and fasten it from the
inside of the door
h using the six
screws provided.
Dishwasher installation
54