Filter
Top Products
^
Place a template on each end of the
mounting bracket as shown, making
sure the rule marks face the outside
of the bracket.
^
Hang the mounting bracket on the
machine door.
^
Slide the top edge of the templates
under the filler strips and control
panel.
^
Slide the bracket up or down until the
oblong holes on the machine door
line up with the oblong holes on the
template (shown in inset a).
^ Draw a line on each template that is
even with the top edge of the adja-
cent cabinet door (inset b).
^ Remove the bracket from the door.
^ Place the door panel on a flat sur-
face, good side facing down, taking
care not to scratch the surface. Make
certain that the bottom of the panel is
closest to you.
^
Place the bracket on the back of the
door panel and adjust it so that:
–
the lines drawn on the templates
align with the upper edge of the door
panel.
–
the mounting bracket is centered (left
to right) on the door panel.
Installation
21