Filter
Top Products
It is important to do this every time
the stainless steel surfaces are
cleaned, as the stainless steel
conditioner protects the surfaces
and helps prevent re-soiling.
Cleaning the ice cube tray
The ice cubes are formed in a tray
before they are dropped down into the
drawer.
This tray should be cleaned regularly to
remove any stale ice or water.
^ Connect the appliance to the
electricity supply.
^ Open the top left drawer a little.
^ Press the On/Off button on the ice
cube maker. The indicator light will
come on.
^ Empty the ice cube drawer.
^ Press the On/Off button on the ice
cube maker and hold it pressed in for
approx. 10 seconds (after about a
second, the ice cube maker will
switch off and the indicator light will
go out).
The indicator light will flash.
^
Push the ice cube drawer in as far as
it will go within the next 60 seconds.
The ice cube tray will then rotate into an
angled position which makes it easier
for cleaning:
^
Wait until the ice cube tray has
completed this rotation before
continuing.
^
Then take the ice cube drawer out of
the appliance and clean it.
^ Now clean the ice cube tray with hot
water and a little washing-up liquid or
sterilising fluid. Rinse thoroughly
afterwards.
^ Press the On/Off button on the ice
cube maker.
^ Then put the ice cube drawer back in
the appliance and close it.
The ice cube tray will return to its
original position.
The ice cube maker will begin to
produce ice cubes again after a
maximum of 6 hours.
If the ice cube maker has not been
used for a while, it is important to
clean the ice cube tray before using
it again.
Cleaning and care
43