..."dn" appears in the temperature
display.
The demonstration function is activated.
^
Call the Service Department.
. . . you cannot switch the ice cube
maker on.
^
Check whether the appliance is
connected to the electricity supply.
. . . the ice cube maker is not
producing any ice cubes.
^
Was the water inlet pipe purged of air
by a qualified and competent person
before the appliance was used for
the first time?
^ Check whether the ice cube maker is
switched on.
^ Check whether the freezer section is
switched on.
^ Check whether the water inlet is
open.
^
Check that the ice cube drawer has
been closed properly.
It can take up to 24 hours to produce
the first ice cubes.
. . . the ice cube maker is only
producing small ice cubes.
The size of ice cubes which are
produced over a certain period of time
will depend on the water pressure
present.
If the ice cube maker is only producing
small ice cubes, the water pressure is
low.
^
Lengthen the water intake time for the
ice cube maker (see "Making ice
cubes").
. . . the indicator light on the ice cube
maker flashes.
The ice cube tray is in its cleaning
position (see "Cleaning and care").
If this is not the case, then there is a
fault.
^
Call the Service Department.
. . . you cannot switch the appliance
off.
The safety lock has been activated.
. . . the interior lighting in the
refrigerator section is not working.
^ Was the door left open for too long?
The lighting switches itself off
automatically after approx. 15
minutes if the door is left open.
If this is not the case, then the interior
lighting is defective.
^
Disconnect the appliance from the
mains. Switch off at the wall and
withdraw the plug from the socket, or
disconnect the mains fuse or remove
the screw-out fuse in countries where
this is applicable.
Problem solving guide
49